NGX Saw Plate with 55 in. Non-Chip Strip by BORA

No matter how accurate your cuts are, ugly tear-out can still happen. End tear-out for good with the NGX Saw Plate and Non-Chip Strip, specifically designed as part of the BORA NGX Clamp Edge System. With its easy-to-use, intuitive design, you can apply the strip and mount your saw to rip or crosscut a board in no time. An especially helpful feature of the saw plate is the all-new non-chip strip, which saves your boards from tear-out. Simply press this self-adhesive strip onto the clamp edge and cut-the excess width of the strip will come off so the edge of the non-chip strip sits flat against your blade and is parallel to your clamp edge.

• Fixed center molded channel reduces blade offset and guesswork
• Self-adhesive non-chip strip attaches to the bottom of your NGX clamp edge and reduces top edge tear-out for a smooth finish
• Quick-release clamps are adjustable so your saw goes on and off the plate effortlessly
• Aluminum guide rails position your saw accurately every time
• 3 points of contact hold the saw securely while cutting
• Fits right- or left-handed saws
• Part of the NGX Clamp Edge System to cut and rip sheets and boards